Ec Declaration Of Conformity - Berner 180784 Bedienungsanleitung

Using:
1. Connect on the power.
2. Spin the switch, choose the suitable one
(Picture-2, 1 ventilation /2 ventilation & medium temperature /3 ventilation & high temperature).
3. Turn the Thermostat to choose the temperature (0 - 85°C) (Picture-2, 4 Thermostat), the Heater begin to work.
4. After power-off, the fans will go on wheeling if inner temperature is higher than 50°C until the temperature is
lower than 50°C then the fans will stop.
3. Ventilation
& high
temperature
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that the product described under "Technical Data" fulfi lls all the relevant
provisions of the directives. The Low Voltage Directive 2006/95/EC, 2006/95/EC (valid until 19 April, 2016), 2014/35/EU (ef-
fective from 20 April, 2016) and the following harmonized standards have been used:
EN 60335-2-30:2009+A11:2012
EN 60335-1:2012+AC:2014+A11:2014
EN 62233:2008
Berner Trading Holding GmbH
Berner Straße 6
D-74653 Künzelsau
Künzelsau, 10.08.2017
Picture 1
0. Off
1. Ventilation
2. Ventilation &
low temperature
Picture 2
1. Switch
2. Thermostats
3. Power plug
4. Thermostats
i.V. Bert Habets
Senior Director Continuous Improvements
(GB)