Power Supply - auna multimedia 10021826 Bedienungsanleitung

Power Supply

Connect AC power
Caution:
Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the
·
rating label located on back or bottom of the unit.
Warning:
Risk of electric shock! When you disconnect the AC power, always pull the plug from the wall outlet.
·
Note: Install the unit near the wall outlet and where the AC power plug can be easily reached.
1. Connect the power cord to the AC IN jack on the unit and to the wall outlet.
2. To save energy: After use, set the switch to OFF.
Install/Replace the Unit Batteries (not included)
Note: You can use both batteries and AC power as power supply of this unit.
1. Open the battery compartment.
2. Insert 6xUM-2 batteries with correct polarity (+/-) as indicated.
3. Close the battery compartment.
Handling the batteries
Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause fire,
·
personal injury or damage to property.
When the batteries are exhausted, the appliance will not function. Replace both batteries at the same
·
time with new ones.
Use only the types of batteries indicated in this manual.
·
Do not install new batteries with used ones and do not mix different types of batteries.
·
Do not dispose of used batteries as domestic waste. Dispose of them in accordance with local
·
regulations.
Remove batteries from the unit if you do not plan to use it for a long period of time, otherwise the batteries
·
may leak.
Note: When replacing the batteries, make sure you dispose of the old batteries in accordance with
applicable regulations. They should be disposed of in a location specifically designated for that
purpose so they can be recycled safely and without posing any risk for the environment. Do not burn
or bury them.
ENG-5
9