Device Description - Kress 420 ST E Originalbetriebsanleitung

18 English

3. Device description

Read all the warnings and instruc-
EN
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Device components
1 On/off switch
2 Electronic adjusting dial
3 Dust hood
4 Base plate
5 Saw bench mounting
6 Clamping wheel
7 Saw blade
8 Clamping lever
9 Dust extractor ø 35 mm
10 Chip-flyoff guard
11 Parallel fence
12 Mains cable module 500 ST E
Fixed supply 420 ST E
13 Interlock button mains cable module
14 Pendulum stroke adjusting knob 500 ST E
Scope of supply
See packaging
Specified conditions of use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the work-
piece. It is suitable for straight and curved cuts
with mitre angles to 45°. The saw blade recom-
mendations are to be observed.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
ST-EN / 1105
Technical data
Jig saw
V~
Nominal voltage
Watt
Input power
Watt
Output power
min
min
Idling speed stroke
number n
0
mm
Stroke height
Pendulum stroke
levels
°
°
Mitre cut
mm
Cutting capacity,
max. in wood
mm
Cutting capacity,
max. in non-alloy
steel
kg
Weight
Your power tool is double-insulated in
accordance with EN 60745; For this
reason an earth wire is not required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and
is immune to disturbances in accordance with
EN 55014-2.
Device description
420 ST E 500 ST E
230
420
215
-1
500..2700 600...3400
-1
3600
19
--
22,5
45
70
4
1,8
230
500
270
19
3
22,5
45
80
5
2,3