Full Memory; Troubleshooting; Notes/Settings - Hama CallBlocker Bedienungsanleitung

6: Removing all prefixes from the list: PW *#
Confirm and end by hanging up the receiver. No prefixes are blocked.
7: Blocking prefixes for mobile phones: PW 015# PW 016# PW 017#
Confirm and end by hanging up the receiver. All mobile phone networks are blocked.
Remarque : This list of prefixes was current at the time this manual was printed.
8: Blocking prefixes for mobile phones: PW 015# PW 016# PW 017#
AND enabling a mobile telephone number: PW 0171 123456*
Confirm and end by hanging up the receiver.
All mobile networks are blocked, but one mobile number is enabled.
Remarque : This list of prefixes was current at the time this manual was printed.
9: Blocking all telephone numbers: PW 0# PW 1# PW 2# PW 3# PW 4# PW 5# PW 6# PW 7#
PW 8# PW 9# AND enabling four telephone numbers: PW 0171 123456* PW 123456* PW
7891234* PW 6598752*
Confirm and end by hanging up the receiver. Complete block, four telephone numbers enabled.
10. International block: PW 00#
Confirm and end by hanging up the receiver.
All international calls are blocked.
11: Switching on call-by-call recognition: PW ##
Confirm and end by hanging up the receiver.
The CallBlocker recognizes if a telephone number with a cost-saving prefix 010xy is dialled and then
blocks the undesirable numbers.
RECOMMENDATION: Always switch on call-by-call recognition
12: Switching off call-by-call recognition: PW **
Confirm and end by hanging up the receiver.
The CallBlocker does not recognize if a telephone number with a cost-saving prefix 010xy is dialled.
RECOMMENDATION: Always switch on this feature, except possibly when programming.
Remarque : Examples 1 through 12 were selected randomly. Any combination can be entered.
In other words, after entering the password, you can set a time limit and program different prefixes and
telephone numbers.

12. Full memory

The CallBlocker's memory allows up to 16 prefixes (blocked or enabled) and up to 10 (VIP) telephone
numbers. Prefixes are considered numbers with 1 to 4 digits. Telephone numbers have 5 to 11 or more
digits including the prefix.
Once the CallBlocker's memory is full, no more entries can be made. The blocker acknowledges entries
with a long dial tone.
In this case, check the entries you have made and delete some or all of them as described in this
manual.
26

13. Troubleshooting

Problem:
I can't dial out (since the CallBlocker is connected).
Solution:
Your telephone may be a pulse dialling telephone. Switch it to touchtone, or use a touchtone phone.
Problem:
I can't program.
Solution:
The programming switch is not switched to PROGR EIN, or the memory is full. Delete the entries you no
longer need from the memory.
Check whether the CallBlocker and telephone are connected properly.
Problem:
I hear rattling when I pick up the phone.
Solution:
You may have an old AWADo or AMS telephone toggle switch installed. Replace it with another version.
Problems with small PABX devices or terminal adapters:
Some small terminal adapters do not provide the correct voltage. The voltage is only high enough for
one telephone to work. Terminals may not be compatible with each other. Modems and cordless tele-
phones are the most compatible. Check whether the error still occurs with other terminals (telephone).
A different terminal adapter may be the solution.
Remarque : The CallBlocker does not have a W or E-core.

14. Notes/Settings

Settings can be noted down here
Enable emergency numbers!!!
© Böhm-Elektronik 2002, 2003, 2004 Version: 26.07.2004 V1.0 Errors excepted; subject to changes
27