Changing The Password J); Forgot The Password? K); Timer Off; Deleting Programming - Hama CallBlocker Bedienungsanleitung

All conversations will be stopped after 5 minutes. You will hear a warning signal shortly before calls are
interrupted.
Possible entries:
0

= TIMER OFF

1 ... 9 = Time limit is 1 9 minutes
Factory setting: TIMER OFF
i) Changing the password
The password, which is factory-set to 0000, can be changed.
To do so:
- Pick up the receiver
- Enter password ##0000 (dial tone) # (dial tone)
- Enter a new password: *xxxx# (dial tone)
- Hang up the receiver. The new password is stored. "xxxx" stands for your new password,
which consists of numbers 0 9.
j) Forgot the password?
You can delete the password if you forget it.
To do so:
- Pick up the receiver
- Press the pound key seven times "## ## ## #" (dial tone)
- Hang up the receiver. The password is reset to 0000 (factory setting)
k) Checking the settings
You should write down all your entries and check to make sure they function properly.
If you use the factory settings for example, you must check the following numbers on all connected
terminals:
Number:
0190 123
0900 123
010xy 0190 123
010xy 0900 123
0191 123
010xy 0901 123
xy stands for any number (2 or 3 digits) between 0 and 9 (call-by-call test).
If you have changed the factory settings or set any additional blocks, you must expand or adjust the
function test.
Example: You have also blocked the prefix 038 but enabled number 0381 123456. Call-by-call recognition
is on.
CallBlocker reaction:
Warning tone and dialling interrupted
Warning tone and dialling interrupted
Warning tone and dialling interrupted
Warning tone and dialling interrupted
No reaction; number is not blocked
No reaction; number is not blocked
22
Number:
038 6789
0381 1234567
010xy 038 6789
010xy 0381 1234567
Important: If the CallBlocker does not function as expected, a programming error was made, a function
is faulty or another problem exists. You must resolve the problem immediately. See section 13:
Troubleshooting

8. Deleting programming

You have up to 16 memory locations for prefixes (1 to 4 digits) and up to 10 memory locations for
telephone numbers (1 to 11or more digits). For example, you can block 6 telephone numbers and enable
4 VIP numbers.
To delete the list of all prefixes, whether blocked or enabled, proceed as follows: (always wait for the
CallBlocker dial tones)
To do so:
- Pick up the receiver
- Enter password ##0000 (dial tone) # (dial tone)
- Delete list of all prefixes: *# (dial tone)
- Hang up the receiver or enter additional commands beginning with the password
The entire list of prefixes in the CallBlocker's memory is deleted, and space is available for up to 16 new
entries.
To delete the list of all telephone numbers, whether blocked or enabled, proceed as follows: (always
wait for the CallBlocker dial tones)
To do so:
- Pick up the receiver
- Enter password ##0000 (dial tone) # (dial tone)
- Delete list of all telephone numbers: #* (dial tone)
- Hang up the receiver or enter additional commands beginning with the password
The entire list of telephone numbers in the CallBlocker's memory is deleted, and space is available for
up to 10 new entries.
Deleting both lists is a good idea if you are not sure whether older entries that are no longer required
have been deleted. They would take up memory unnecessarily.
If the memory is full, the CallBlocker does not accept any entries and issues a long dial tone or paired
tone.
CallBlocker reaction:
Warning tone and dialling interrupted
No reaction; number (not blocked) is enabled
Warning tone and dialling interrupted
No reaction; number (not blocked) is enabled
23