Loading Negatives - Klarstein 10004236 Benutzerhandbuch

5.Loading Negatives

Hold up the negative toward the light. As you
look through the negative you should be able to
read the small negative numbers normally
(not a mirror image).
Now turn the negative so the image is upside
down while looking at the same side.
Open the negative holder at the marked spot
on the top.
With the negative holder laid open place the
negative into holder so the notches line up with
the notches on the holder.
Note: Handle negatives with care. Any dust,
scratches or fingerprints will show up on your
saved images. If possible use cotton gloves
when handling negatives. It is recommended to
use compressed air to remove any dust on the
negatives. This is not included with the film &
photo scanner but can be purchased from an
office supply or electronics retailer.
Close the negative holder and press the edges
so that it locks in place
Hold it in the position as shown in the film &
photo scanner.
Insert the negative holder into the slot on the
right side of the film & photo scanner as shown.
Film Holder: The design of the film holder is
follow ISO standard. In some cases the holes on
the film will not match exactly to alignment of the
holder. This is caused by a non-standard camera.
In this case there will be a small black line on the
edge of the frame that can easily be cropped out
using photo editing software.
ISO– International Organization for Standardization
5