General Instructions - Jms Racelook-Pedal Anleitung

Installation racelook-pedal

General instructions

Please carefully read and understand this manual completely before attempting installation.
The racelook-pedal has been carefully designed and rigorously tested. By following the instructions and advice in
this manual you will avoid incorrect fitment and ensure maximum enjoyment without running the risk of voiding
the guarantee.
Never install or remove the racelook-pedal system with the key in the ignition or the ignition system active.
Always switch off the ignition and wait 5 minutes for all electrical systems to power down and fully discharge.
On most vehicles the connection for the racelook-pedal is close to the accelerator pedal or the steering column.
You must ensure that the racelook-pedal and the associated wiring loom do not interfere with the operation of the
pedal or the steering and are secured at all times. Do not modify the racelook-pedal or wiring loom in anyway. Any
modifications will result in voiding of the guarantee.
! N.B. Ensure that the harness is secure and does not interfere with the safe operation of the vehicle !
5