ABC Design Kiddie Ride On Bedienungsanleitung Seite 8

1. Mounting the fixture on the frame
a) Undo and remove the bolt (1) and spacer (2).
b) Pull the plastic strap with the thread out of the fixture housing.
c) Fit the plastic strap to the rear of your pushchair frame in order to attach the fixture.
Make sure that the strap is tightly fitted on the frame.
d) Push the fixture housing onto the strap.
Feed the end of the strap and thread through the openings provided in the housing.
e) Fit the spacer on the bolt (1) and tighten the nut (2).
2. Attaching the wheels
Insert the wheels in the fittings.
3. Fitting the product on the pushchair
Adapt the "Kiddie Ride On" to fit the size of your frame by adjusting the mounting brackets.
First, undo the bolts (1) on both sides of the underside of the platform.
Fit the mounting brackets in the platform and move them to the right position (2).
Then secure the mounting brackets by retightening the bolts (1).
Make sure that both sides are equidistant.
Fit the mounting brackets. Pull back the button on the mounting (1). Now you can secure the brackets on
the mounting (2).
Make sure that the catch is properly engaged!
4. Adjustments
To adjust the length, push the buttons (1) at the top of both mounting brackets.
Set to the required length (2).
When adjusting the length, please make sure that the platform is behind the brakes and the wheels!
To adjust the height, push the buttons at the bottom of both mounting brackets (1) and move the brackets
to the right position (2).
When adjusting the height, make sure that the wheels maintain contact with the ground!
5. Stowing the product
Insert the plastic clip in the slot provided.
Now you can raise and stow the platform by securing the strap to the frame.
6. Removing the product
Press the button on the bracket (1) backwards to release the catch.
You can now take the brackets from the mounting and remove the "Kiddie Ride On".
The mountings can be left on the frame.
EN - 04