Measuring The Temperature Of An Object - Telefunken NCT series Gebrauchsanweisung

GB
3 Operation

3.4 Measuring the temperature of an object

1. Move the selector switch
object temperature measurement mode
2. Press the ON/OFF button
The thermometer performs a self-test, where all the display
symbols are shown in succession.
3. Finally, the last registered reading is displayed along with the
M symbol (M = memory) for 2 seconds.
4. When you hear a short beep and the the symbol for the
measuring unit °C flashes, the thermometer is ready to take
the measurement.
5. To begin the measurement, point the sensor
of the object at a distance of no more than 5 cm. If it has water,
dust or dirt on it, remove this first so that the reading is as
accurate as possible.
6. Press the START button
and the temperature is measured. The measurement is
accompanied by a series of beeps.
7. Release the START button
beep indicates the end of the measurement. Remove the
6
sensor from the measuring position. The display shows the
measured temperature.
3.5 Recalling stored data
The TELEFUNKEN
results. You can call up your stored data with a short press of the
START button
thermometer with the ON/OFF button
flash on the display next to "- - -". After a further short press of the
START button
display, followed directly by the last stored temperature reading.
The symbol M will flash below the unit of measurement. With a
further press of the START button
stored in memory slot "2". A total of 30 memory slots are available,
and these will be displayed in order if you continue to press the
START button
will appear next to it in the display.
24
7
to the bottom position to select
3 1
. The LC display
2
. The blue light
2
after a few seconds. A long
NCT infrared thermometer can store up to 30
2
, without having previously switched on the
2
, memory slot number 1 will appear in the unlit
2
. If a memory slot is empty, the symbol "- - -"
.
is activated.
6
at the middle
5
switches on
3
. The symbol M will
2
, you can call up the result
G