Disposal Considerations; Declaration Of Conformity - Klarstein 10028136 Bedienungsanleitung

Problem
Spray nozzle does not
spray.
Machine does not start.
Streaks whlle cleaning.
Water is leaking.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Your product contains batteries covered by the European Directive. 2006/66/EC, which cannot be
disposed of with normal household waste. Please check local rules on separate collection of batteries.
The correct disposal of batteries helps prevent potentially negative consequences on the environ-
ment and human health.
Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2004/108/EC (EMC)
2011/65/EU (RoHS)
2006/95/EC (LVD)
9
Troubleshooting
Possible cause and solution
• There is no water in the water tank, refi ll with water.
• Spray nozzle is screwed too tight, adjust the tightness of spray
nozzle.
• Spray nozzle is blocked, remove the spray nozzle and clean the
internal parts.
• Pump mechanism in sprayer defective, contact the dealer.
• Check the charge/operations indicator.
• If the indicator will blinks every 2- 3 seconds: Charge the battery.
• Switch the appliance on, the charge/operations indicator is not on
or blinking rapidly: contact the dealer.
• Clean the removable rubber strip.
• Reverse the used removable rubber strip.
• Undo fi ve screws and pull the removable rubber strip out of the
suction wiper toward the side. Moisten the rubber strip rounded
side with water or detergent. Reinstall the rubber strip into the
holder with the reverse side fi rst.
• If both edges are worn after the rubber strip was reversed, you
will need to install new strip. Replace the removable rubber strip
as described above.
• Empty the water tank (max. 110 ml).

Disposal Considerations

Declaration of Conformity