Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When done successfully, then the 1. Programming level
is displayed for change:
Now the temperature display can be changed from ° C
individually via the two control buttons
SC.-C.: display of ° C
SC.-F.: display of ° F
2.2 Display/Change of Control algorithm as 2-point or PID (AL- ~)
Possible Settings:
2 – two point-control
P – PID-control
3.Step:
press both control buttons SET (full left)
and
(up) (full right) simultaneously (see pic B.)
when done successfully, then the 2. Programming level is displayed
for change:
Now the control algorithm can be changed from 2-point to PID-
control, individually via the two control buttons
Note:
For basic heating procedures, where casual overshoots can be accepted and
do not lead to any subsequent damages on the to be heated product, the two
point control algorithm countervails (A.L.-.2.), for any other heating procedure
it is recommended to set to PID control algorithm (A.L.-.P.).
2.3 Display/Change of Sensor type (St - ~)
Possible Settings:
Pt100
Fe-CuNi
NiCr-Ni
4.Step:
press both control buttons SET (full left)
and
(up) (full right) simultaneously (see pic C.)
ie. ‚ 123.'
ie. ‚ 123.‚
A.L.-.2.
A.L.-.P.
P
F
n
SC - C or SC - F
(down) or
AL - 2 or AL - P
(down) or
St - P
St - F
St - n
° F,
(up)
Pic B.
(up)
Pic C.
11
Werbung
Inhaltsverzeichnis
