Massoth Dimax 8133301 Kurzbeschreibung Seite 11

3. Hook-up and Operation
Release the 5 screws as shown in Ill. 1. After taking of the back co-
ver of the casing you can see the main circuit board (Ill. 2), the
connector for cable use and the display. The connector for the RC
sender is located on the right side directly below the display.
Connect the RC sender with this connector as shown in the drawing
above. Make sure that all ten pins are connected correctly. If not this
may cause unreparable damage to the electronics. After installation
take the back cover, assemble the casing and screw in the five
screws.
Dimax-Funksender / Dimax-RC Sender – 8133301 10