Operation - Blaupunkt BP3033 Bedienungsanleitung

Fig. 4
Installing A Grinding Disc (Fig. 7)
WARNING: Always use the supplied flange wrench for slackening and tightening the flange nut.
• Lock the disc guard onto the spindle housing.
• Press the spindle lock button (1) and rotate the clamp nut (2) until the spindle locks.
• Turn the clamp nut counter clockwise and remove it from spindle.
• Place the grinding disc over the spindle with the concave side of the disc (6) facing outward.
• crew the clamp nut (2) onto the spindle with the flat side of nut facing up. Fit the raised small diameter portion of the clamp
nut into the hole in the grinding disc. Tighten to finger tight only.
• Depress the spindle lock button and rotate the grinding disc clockwise until the spindle locks.
• Securely tighten the clamp nut with the wrench provided.

Operation

On/O Switch (Fig.8)
• To turn the switch ON, press the back of the switch slider (1) into the body of the tool. While pressing on the rear of the slider,
push it forward (2) until the front part of the switch (3) engages the catch.
• When the switch "snaps" into position, the switch will remain ON and the motor will continue running.
• To turn the switch OFF, press the rear of the slider into the angle grinder body. The switch will "snap" to the OFF position.
Fig. 5
Fig. 8
Fig. 6