HK Audio LUCAS NANO 608i Handbuch Seite 10

LUCAS NANO 608i 1.0
4 Setups and Accessories
You can deploy LUCAS NANO 608i in various confi gurations. The optional
HK Audio accessories listed in section 4.7 let you do this with the greatest
fl exibility and convenience.
4.1 Mono Cube
Balance Connect the two LUCAS NANO 608i satellites to the
Setup
subwoofer as described in chapter 1. Be sure to set the Setup
L R
selector to 'Satellite Array' and the Balance knob to the
Speaker Out
center or 12 o'clock position.
L R
• You don't need any additional accessories for this setup.
4.2 Mono System A
With the S-CONNECT POLE LN
(see the picture below)
Screw the S-CONNECT POLE LN into the M33 pole mount on
Balance
the subwoofer's top panel. Then attach the satellite array to
Setup
the S-CONNECT POLE LN adapter sleeve via the Easy-Click
L R
Speaker Out
connector. The signal bus is built in, so you don't need to
connect any speaker cables for this setup. Be sure to set the
Setup selector to 'Satellite Array' and the Balance knob to
L R
the center or 12 o'clock position.
• Required accessories: S-CONNECT POLE LN
4.3 Mono System B
With the LUCAS NANO 600 MONO STAND ADD-ON or in
combination with a standard 35 mm/M20 speaker extension pole
(see the picture below)
Screw the included M33-to-M20 adapter sleeve into the pole
Balance
mount on the subwoofer's top panel. Screw the speaker pole
Setup
that comes with the MONO STAND ADD-ON kit into the pole
L R
Speaker Out
mount and attach the POLE MOUNT ADAPTER included in the
ADD-ON kit to the speaker pole's top end.
L R
Signal via
Easy-Click
Bold black:
Part of the listed
accessory sets
10
4.1 Mono Cube
No cables needed
Then attach the satellite array to the POLE MOUNT ADAPTER via the Easy-Click connector.
Be advised that the POLE MOUNT ADAPTER does not route the signal to the satellites;
you will have to use a Speakon®-compatible speaker cable to connect the subwoofer's
Speaker Out L port to the satellite array. Be sure to set the Setup selector to 'Satellite
Array' and the Balance knob to the center or 12 o'clock position.
• Required accessories: MONO STAND ADD-ON (1 two-piece speaker pole
with stand adapter, 1 speaker cord, 1 bag)
This setup option works with any standard 35 mm/M20 speaker extension
pole. All you need is the POLE MOUNT ADAPTER to attach the satellites.
4.4 Stereo System A
With the LUCAS NANO 600 STEREO STAND ADD-ON or in
combination with standard microphone stands with a 3/8" thread
(see the picture below)
Place the two LUCAS NANO 608i satellites on the
Balance
STEREO STAND ADD-ON speaker stands' 3/8" threads
Setup
and screw them down. Now connect the satellites to
L R
the subwoofer's two Speaker Outs using Speakon®-
Speaker Out
compatible speaker cables. Be sure to set the Setup
selector to 'Stereo Satellite' and the Balance knob to
L R
the center or 12 o'clock position.
• Required accessories: STEREO STAND ADD-ON (2 height-adjustable
speaker stands, 2 speaker cords, 1 bag)
This setup option works with any standard microphone stand, provided it is
fi tted with a 3/8" thread.
4.2 Mono System A
with S-CONNECT POLE LN
No cables needed
One
speaker
cable
M20
needed
Adapter
4.3 Mono System B
with MONO STAND ADD-ON