Team International FM 117 IR Gebrauchsanleitung Seite 8

Fax +32 2 359 95 50

IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
USE
Your appliance is delivered with massaging rollers. In order to place them you only have to put
them in the therefore forseen housings and to push them lightly. If you don‟t want to use them,
please place the other accessories in the same housings.
 Fill the tub of the unit with warm or lukewarm water (attention, your appliance is not
foreseen to heat water but rather to keep it warm enough during the treatment).
 The mark „MAX‟ shows the maximum fill level. If you want to fill the unit with less water,
please make sure that there is a sufficient amount of water over the foot rest surface.
 Place the unit on the floor in front of a chair. The rubber pads on the unit prevent it from
sliding.
 Plug in the power cord and set the switch to the desired application.
 Please sit down before putting your feet in the tub. Do not stand in the tub for a prolonged
period of time!
 Relax and enjoy the gently stimulating foot massage and the refreshingly bubbling water.
You can enhance the effect with non-foaming bath oils.
 To relax the sole of your foot, you can also lay your foot on the infrared insert situated on
the edge of the appliance. However, please note that the infrared heat will only be
produced if the programme selector is on a position including infrared heat. (see below)
 After 10-15 minutes you can end the foot massage bath and switch off the unit. Unplug
the power cord necessarily before emptying the tub.
 We recommend resting afterward for an extended period of time (bed or couch) with
your legs covered.
 To achieve long-term results, regular use (once or twice daily) is required.
Off
Massage Heat Infrared Heat
Massage Heat Bubble Infrared Heat = Foot massage, bubbles, warm water and infrared
Bubble Heat
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
= Turns the unit off.
= Foot massage with infrared heat
= Bubbles and warm water
8
Assembly page 8/28