Open/Close Button - Chal-Tec 10006447 Anschluss- Und Anwendungshinweise

5. OPEN/CLOSE button

6. +10 – button: You can skip 10 tracks on the CD by pressing this button.
7. SGL/CTN button: You can switch the CD player between single track playback (SINGLE) and
continuous track playback (CONTINUOUS) with this button.
8. PITCH - % key: The maximum PITCH speed change is switched between 4%, 8% and 16% with
this key. The corresponding LED 4, 8 or 16 goes on.
9. TIME button: A short press of this button switches between the various CD time counters on the
LC display.
10. : backward track skip / : forward track skip
11. LOOP – OUT button: The end point of the playback loop is set and the playback loop started
simultaneously by pressing this button. The playback loop is ended by pressing the button again.
12. RELAY button: This button is used to activate or deactivate the RELAY function. The LED above
the button goes on if the RELAY function is activated.
13. PITCH button: This button is used to activate the "PITCH slide control" (3) function. The LED
above the button goes on whenever the PITCH function is switched on.
14. PITCH – BEND buttons: The playback speed of the CD player can be increased or reduced
temporarily by 16% with these buttons. Pitch bend (-) button = reduces the speed / Pitch bend
(+) button = increases the speed
15. SEARCH button:  = backward search /  = forward search
16. RELOOP button: This button allows you to retrieve a saved playback loop. The LOOP -OUT button
must be pressed to end the playback loop.
17. PLAY/PAUSE button: The CD is played or switched to pause mode with this button. The green
LED next to the button goes on in playback mode and flashes in pause mode.
18. CUE button - during playback: The CD player returns to the beginning of the piece of music or to
the previously selected CUE mark and switches to pause mode if the CUE button is pressed
during playback. CUE function in pause mode: You can pre-hear tracks by holding down the CUE
button with the CD player in pause mode. The CD player returns to the beginning or song or to
the CUE mark as soon as the CUE button is let go of.
19. System connection socket of the CD control unit
Attention: With the help of a fader of a mixer it is possible to cross-fade from one CD-player to the other.
Player:
20. CD compartment 2
21. OPEN/CLOSE button for CD compartment 2
22. CD compartment 1
23. OPEN/CLOSE button for CD compartment 1
24. ON/OFF "POWER" switch
25. System connection socket
26. AC INPUT" mains connection
27. AUDIO – OUT R&L sockets: The right and left audio signals of CD player 2 are output in analogue
form at these cinch sockets. Connect the audio input of your mixer or amplifier here.
28. FUSE Socket