Maintenance And Cleaning - Team International MAS 3 Gebrauchsanleitung

Fax +32 2 359 95 50

 2 shaping discs (14 and 15) to file fingernails or toenails
 2 cuticle lifters (10 and 16) for lifting up cuticle (lead the appliance slowly along the edge
of the nails.
 2 polishing discs (6 and 7) to smooth round nail edges after filing and to polish nail surface.
You can use these attachments to finish the job of the other attachments.
 1 brush (11) to remove powdery nail residue from filing.
The speed selection (1 = slow, 2 = fast) essentially depends on the hardness of the surface you
want to treat, on the sensitiveness of the user and of the required precision. Both speeds can
be used with any attachment.
ASSEMBLY OF THE ATTACHMENTS
To connect the attachments to the unit of the appliance, plug them directly in onto the motor
shaft. To remove them, pull them out from the head.

MAINTENANCE AND CLEANING

 Always unplug the adapter your appliance before cleaning it.
 Clean the unit of the appliance with a soft damp cloth.
 Do not use any detergent nor abrasive products.
 Use a cloth with a little bit of alcohol or a brush to clean the discs and cones (except the
polishing cone). Do not use the cleaning brush delivered with the appliance, as it could
get damaged by the abrasive surfaces.
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/28
on the
TEAM MAS 3 -060418