Operating Elements - Monacor PA-24FMM Installations- Und Bedienungsanleitung

1
Insertion Module for
Emergency Announcements
These instructions are intended for the techni-
cian installing the insertion module and for users
without any specific technical knowledge . Please
read the instructions carefully prior to operation
and keep them for later reference .
1 Applications
The module PA-24FMM is designed for installa-
tion into MONACOR PA amplifiers with insertion
compartment and for installation into the basic
unit PA-1200EX; however, these instructions
will not refer separately to the basic unit . With
this module, important announcements can
be made via the PA amplifier . In addition, an
emergency message of up to one minute can
be stored and automatically replayed when an
alarm is triggered .
To send an alarm to additional units, a relay
with switching contact is available . This relay will
also respond when the hand-held microphone
is removed or when it is defective . As an addi-
tional alarm feature, an integrated buzzer can
be activated .
8
PA-24FMM
BEEPER
ON
OFF
FAULT
0 10
MIC
2 3 4
RECORDING
L
R
SIG CLIP
0 10
LEVEL INPUT
5 6 7 8

2 Operating Elements

1 Support for the hand-held microphone
2 Jack to connect the hand-held microphone
3 Volume control for microphone announce-
ments
4 LED FAULT; keeps flashing when the micro-
phone is not connected, when the micro-
phone is defective and when an alarm is
triggered
5 Button BEEPER to activate / deactivate the
internal alarm buzzer
6 Control LEVEL for the volume of a recording
7 RCA jacks for recording an emergency an-
nouncement with line level (e . g . from an
MP3 player or a PC)
8 LEDs
SIG will light up up at a given volume of
the recording signal
CLIP will light up up to indicate overload
9 LED PLAY; will keep flashing while an an-
nouncement is recorded or while a stored
announcement is replayed
10 Control LEVEL to adjust the volume when
replaying a stored emergency announcement
11 Headphone connection (6 .3 mm jack)
PLAY
PLAY
≥ 32 Ω
0 10
LEVEL
9 10 11