Operation - Renkforce 1886909 Bedienungsanleitung

Installation and fixing
You can fix the converter to a suitable point, e.g. a wall or furniture, by means of the mounting
brackets on the housing (2).
• Install the converter on a suitable, stable base with the mounting brackets and suitable
screws (not included). Depending on the surface, suitable screws and dowels must be used.
Ensure that no existing cables or pipes (including water pipes) are damaged when
drilling mounting holes or securing screws.
• Remove all connected devices and unplug the power adapter from the DC9V mains
connection (7) on the converter before installation.
Ensure that the mains socket for connecting the power adapter is close to the place
of installation.
Proceed as follows to fix the converter with screws:
• Position the converter in the desired installation position as a template. Use a spirit level for
alignment, if necessary.
• Mark the holes for two to four suitable screws through the holes in the mounting brackets
and drill. Depending on the surface, suitable screws and/or dowels may be required. Screws
for wood or for screwing in the wall plugs for masonry are not included with the product and
must be purchased separately.
• Attach the converter with dowels and screws through the mounting holes at both ends.
• Align the converter after fixing it to the base and tighten the screws adequately (not over-
tight). To do this, always use an appropriate screwdriver.
Connecting the converter
Pin assignment
DB9 socket (pin) RS232C
1 DCD
2 SIN (RXD)
3 SOUT (TXD)
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Connection diagrams (schematic)
a) RS232 to RS422 full-duplex
RS232
b) RS232 to RS422 full duplex (multiple connecting devices)
b) RS232 auf RS422 Vollduplex (mehrere Anschlussgeräte)
RS232 RS422
RS422
RS422
c) RS232 to RS232 full duplex (input)
RS232 RS232
RS422
d) RS232 to RS485 half-duplex
RS232
RS485
e) RS232 to RS485 half-duplex (multiple connecting devices)
RS232 RS485
RS485
RS485
f) RS232 to RS232 half-duplex
RS232

Operation

• Connect the RS232 input (6) of the converter to a computer using the enclosed DB9 serial
cable.
• Connect a network cable (RJ45) to the RJ45 network connection (1) to be able to connect the
converter to a network. The cable is not included.
• Use the adapter supplied to directly connect cables and wires for RS422 and RS485
interfaces, if necessary. Use an appropriate screwdriver to screw down the individual wires.
Observe the printed descriptions of the individual connection terminals.
• Start up the converter.
• Connect the low-voltage plug on the power adapter to the DC9V mains connection (7) to
connect the 9V/DC supply voltage. The PWD power LED (5) lights up.
• The converter is now ready for use.
• The RXD (green) (3) and TXD (yellow) (4) LEDS indicate data exchange over the cables by
flashing.
Care and cleaning
• Disconnect the product from the mains before each cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the case or cause the product to malfunction.
• Use a dry, lint-free cloth to clean the product.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to environmental protection.
RS232