Installation - Ossur Icelock lanyard 631 Bedienungsanleitung

ENGLISH
CONTENT
Lanyard Cord with connecting screw (1)
Funnel (2).
Bottom Attachment, lanyard (3).
Elbow, lanyard (4).
Cord Cover 40cm (5).
Cleat with cover and rivets (6).
Pull Handle, lanyard (7).
Fabrication Ring w/ o-ring (8).
Silicone Seal (9).
Cross Driver (10).
Items 8 and 9 are used when the socket is fabricated.
Use with L-680000 Fabrication Tooling (reusable).
Tools required
• 8mm (5/16) socket wrench.

INSTALLATION

• Place Bottom Attachment (3) into bottom of socket with hole for
Lanyard Cord (1) in correct position.
• Shorten Elbow (4) to required length and insert it into hole.
• Screw Funnel (2) into threads above Bottom Attachment (3) and
torque to 8Nm (6ft.lb) using Cross Driver (10) (comes with
Fabrication Tooling) and 8mm torque wrench.
• Find correct positioning for Cleat (6), drill two 3mm (1/8") holes, and
rivet Cleat (6) to socket.
• Trim Cord Cover (5) to desired length. Bond it into Elbow (4) and to
hard socket in alignment with "tunnel" in Cleat (6).
• Thread Lanyard Cord (1) all the way through Bottom Attachment (3),
Elbow (4) and Cord Cover (5).
• Screw connecting screw on Lanyard Cord (1) into distal end of
Locking Liner, don socket and secure Cord in Cleat (6).
Important: Tie knot (11) in Lanyard Cord (1) to stop it from inadvertently
being pulled into channel.
Note: Pull Handle (7) can be used for a more secure grip on Lanyard Cord
(1) when socket is donned.
1 year limited warranty.
It is recommended that Lanyard Cord (1) be regularly checked for wear.
Rated up to high activity level (K3). Distal/weight bearing adapter
determines weight limit.
Other locking components available for 600 series:
L-621000 Icelock ratchet 621.
L-641000 Icelock valve 641.
L-651000 Icelock smooth lock 651.
3