Assembly - RedNeck GD4 Montageanleitung

ASSEMBLY

Attention!
Turn 2-3 times, so that the screw grips on its own and connects all elements loosely. The screws must
only be driven in tightly when all elements are connected with each other in this way. Otherwise the
setup won't be possible. Only by driving them in slightly afterwardsm small deviations of the borehole
or the welded joints, which always occur with handcrafted productsm can be compensated.
Notes for an optimized assenbly:
Before you completely tighten the screws, check carefully all the screws and tighten them to the extent
that the product remains still unter load. If you are sure that your product can withstand load, place it
on a solid, level ground and put some weight on it. Please carefully and always with cushions!
The various components can then align with each other, Then tighten completely the screws. Thus you
achieve an optimal alignment of the product and prevent wobbling.
Dont's
Don't use this product if parts are missingm damaged or worn down.
Don't use any electronic tools to set up these product, it can cause damages!
Don't overtight screws or bolts. Only tighten the screws entirely after the product is completely set up.
Don't let your product stand in the rain. Protect it from weather impacts. We suggest you to store the
product in a covered dry place in times of freeze and over the winter.
Please note, that at first all screws should be inserted slightly by hand.
24