Ingersoll-Rand 327LS Bedienungsanweisung Seite 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
Do not use this tool if actual free speed exceeds the
•
nameplate rpm.
Before mounting an accessory, after any tool repair
•
or whenever a Tire Buffer is issued for use, check
free speed of the Tire Buffer with a tachometer to
make certain its actual speed at 90 psig (6.2
bar/620 kPa) does not exceed rpm stamped or
printed on the nameplate. Tire Buffers in use on
the job must be similarly checked at least once
each shift.
Model 327LS Geared Tire Buffers have a free
•
speed of 3,000 rpm when operated at 90 psig (6.2
bar/620 kPa) air pressure. Operation at higher air
pressure will result in excessive speed.
After mounting a new accessory, hold the Tire
•
Buffer under a steel workbench or inside the tire
and run for at least 60 seconds. Make certain no
one is within the operating plane of the accessory.
If the accessory is defective, improperly mounted
WARNING SYMBOL IDENTIFICATION
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.
TIRE BUFFER SPECIFIC WARNINGS
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
or the wrong size and speed, this is the time it will
usually fail.
Do not use any accessory having a maximum
•
operating speed less than the free speed of the Tire
Buffer in which it is being used. Always conform
to maximum rpm on the accessory being used.
Do not use grinding or cut- - off wheels.
•
Do not use wire brushes more than 2 inches in
•
diameter.
Always wear protective eyewear or a face shield
•
when operating a Tire Buffer. Use a face mask or
dust mask if the cutting operation produces an
excessive amount of debris.
When mounting a new accessory, operate the tool
•
at gradually increasing speed and check for good
balance of the accessory. If there is excessive
vibration, do not use the accessory.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________