Herunterladen Diese Seite drucken

h.koenig U600 Bedienungsanleitung Seite 6

Schuhputzmaschine

Werbung

22. Make sure that the voltage rating on the typeplate
corresponds to your main voltage of your installation.
If this is not the case, contact the dealer and do not
connect the unit
23. Never leave the unit unattended while in operation.
SAVE THESE INSTRUCTIONS
Note:
This model is a household shoe polishing machine and works with an intermitttent duty motor.The
duty cycle of the motor is designed to run for 5 minutes continuously and then 5 minutes off before
restarting again.The motor has an automatic overload thermal cutoff which stops the appliance in
case of excessive force which may cause over-heating.In case the overload is tripped, you have to
wait for approximately 10-15 minutes before resuming regular operation.( This depends on the
ambient temperature.)
How to use your shoe polishing machine
1. Press the ON/OFF button on the top of the housing to start the machine.This button is pressed
once for ON and again for OFF.
2. To apply polishing cream to your shoe,lift your shoe and stroke the tap of the dispenser
gently.Natural color shoe cream can be used for any colored shoes.
3. It is strongly recommended that one of the polishing brushes is used for shoes applied natural
color cream and another one, for colored cream. Do not mix use of these two brushes,or
otherwise, it will affect the polishing result occasionally.
4. When polishing is done, press the ON/OFF button again to switch the machine off.
Refill the shoe cream
1. By looking through the wax box indication slot, you can notice when the shoe cream should be
refilled.
2. Unlatch the dispenser and have it move outward to open the dispenser cabinet.
3. Take the bottle out, loose the tap and fill in cream of the same kind.Put the spring and steel ball
in proper position before recapping the tap tightly.Also, make sure the exhaust hole on top of
the bottle is open.Or otherwise, shoe cream will not flow out smoothly when tap is
stroked.Actually , you can take the blocking pin out from the exhaust hole and throw it away at
the first time you have your bottle filled.
4. Put the cream bottle back into the cabinet and latch it in proper position on the machine.

Werbung

loading