Hella marine NaviLED PRO 2 Installationsanweisung

PR O
Approvals
Hella marine NaviLED PRO Port-, Starboard and Stern navigation lamps are type approved and
®
certified by the German Federal Maritime and Hydrographic Agency (BSH) for German inland
waterways and the open sea for vessels less than 50m in length.
They carry the following approval numbers: BSH/4615/6010419/06 and
NaviLED PRO Self Diagnostic Control
®
To ensure long term safety at sea, each BSH certified NaviLED
equipped with a self diagnostic control.
A photometrical self-test is carried out by the lamp in periodic intervals. If the light output, and
consequently the visibility, reaches a pre-determined value, the lamp activates 'Service Mode'.
Service Mode is indicated by the lamp flashing at a rate of 60 flashes per minute for 15 seconds
as soon as the lamp is switched on. This will occur for 15 seconds every time the lamp is
switched on until the unit has operated for 2000 hours.
After 2000 hours the Service Mode flash rate doubles to 120 flashes per minute for 15 seconds
as soon as the lamp is switched on.
To ensure the lamp meets the light output criteria of its certification, Hella marine recommends
the light module be replaced as soon as it enters this 2000 hour Service Mode stage.
The 2000 Service Mode flash rate should not occur earlier than tens of thousands of hours. By
regular recreational boating standards, even with regular night sailing, this stage will hardly ever
be reached.
Warranty Statement
Congratulations! The product you have selected comes from Hella marine - one of the
world's leading manufacturers of marine lighting products.
Hella marine branded products are covered by a warranty against manufacturing or material
defects. (For further details please check the terms of trade with your Hella marine agent).
The lamp module is sealed and does not have any serviceable parts inside; opening the
module will invalidate warranty.
In the unlikely event that you should experience a problem with your purchase,
please contact your Hella marine agent where you purchased the product.
For general comments about Hella's products please contact us on E-mail at techfeedback@hellamarine.com
D.06.419.
® PRO navigation lamp is
PR O
BSH Certified NaviLED
Port / Starboard / Stern Navigation Lamps
Introduction
Hella Marine LED Navigation Lamps offer many advantages over conventional bulb lamps.
Significantly reduced power consumption, ultra long life and high tolerance to shock and vibration
make the LED lamps the ideal choice for the harsh marine environment.
Hella Marine NaviLED ® PRO Navigation Lamps are 'Precision Optical Instruments', tested and type
approved to comply with international maritime regulations.
Installation of Lamps
Navigation Lamps must be mounted as
follows:
Port and Starboard Lamps:
Parallel to the vessel's centre line. (see Fig.1)
Vertical to the vessel's centre line. (see Fig.2)
Stern Lamps:
Right angles to the vessel's centre line.
Vertical to the vessel's centre line. (see Fig.2)
The signal direction arrow should point:
Right ahead for Port / Starboard Lamps (side Lamps)
Right astern for Stern Lamps.
Without obstruction to the light output:
When the Lamp is operating, the light should not be
obstructed or concealed by superstructures or other
objects.
Port / Starboard (side lamps):
Must be mounted in the same thwartships position
at the same height above the construction water line
(CWL), and a minimum of 1m below the Masthead
Lamp and mark the effective beam of the vessel. If this
is not possible, the distance between the individually
mounted side Lamps should not be less than 85% of
the maximum beam of the vessel.
NaviLED PRO Bi-colour Option:
®
Two NaviLED PRO side Lamps may be mounted
®
'back to back' to form a Bi-colour Lamp (see Fig.3)
and used instead of single colour side Lamps.
These must be mounted on the vessels
centre line, and a minimum of 1m below the
Masthead Lamp.
PRO 2 Nautical Mile
®
Fig. 1 Parallel to the vessel's centre line.
e.g. - Port Lamp
Top
112.5 Degrees.
Fig.2 Vertical to the vessel's centre line.
e.g. - Port Lamp
Bow on view
Fig.3 Bi-colour Mounting.
Bow-on view
Starboard Port