Installation Steps - GERATEK Valencia DH116B Bedienungsanleitung

If you have an exhaust air duct to the outside, the extractor hood can be installed
by using an exhaust hose (Diameter of the exhaust hose: s. chapter 6. T
).
DATA
 S. fig. below

2.3.1 Installation steps

1. Find a suitable position for the extractor hood on the wall. Drill three Ø 8 mm
holes in the wall to attach the wall bracket. Insert the enclosed dowels into the
drill holes and fix the bracket to the wall using the screws (ST4*30mm) (s. fig.
below). Ensure that all screws are tightened and that the bracket is anchored in
the wall properly.
1 Drill holes (Ø 8 mm)
2 Dowels
Wall bracket
3
4 Screws (ST4*30 mm)
35
ECHNICAL