Operation - Monacor PA-1140RCD Bedienungsanleitung

4 Installation of the
Insertion Module
WARNING The installation of the insertion must
be made by skilled personnel only!
Prior to the installation of the inser-
tion, disconnect the mains plug of the
amplifier or of the PA-1200EX from
the mains socket . Otherwise there is
an electric shock hazard .
1) Remove the housing cover of the amplifier or of
the PA-1200EX .
2) Screw off the cover for the insertion compart-
ment on the front side of the amplifier or of the
PA-1200EX . Install the insertion and tighten it
with screws .
3) Connect the bare three-pole cable of the ampli-
fier or of the PA-1200EX to the pin housing of
position c (see fig . 2) . This allows to supply the
insertion with 17 V (⎓) and to feed the audio
signal to the amplifier .
4) If required, two further audio outputs are available:
balanced mono output at the connection d
unbalanced stereo output at the connection e
5) To install the supplied antenna jack (fig . 3) on the
rear side of the amplifier or of the PA-1200EX,
unscrew the cover panel (fig . 4) or remove the
cover plate (fig . 5) . Insert the antenna jack into
the opening and tighten it with screws .
6) Connect the cable of the inserted antenna jack to
the five-pole pin housing of position a .
7) The insertion PA-1140RCD has a storage battery
so that the stations also remain stored with the
unit switched off . The storage battery has been
deactivated in the factory to prevent discharge
before installation . To activate the battery, set
the jumper b to position ON .
To deactivate the battery again (e . g . if stored
for a longer time), set the jumper b to position
OFF again .
8) Close the amplifier or the PA-1200EX with the
hous ing cover . Connect the reception antenna to
the antenna jack (fig . 3) . To connect both an FM
antenna and a medium wave an tenna, connect
them to the jack ANT via an antenna combiner .
10
5

Operation

1) Switch on the amplifier or the PA-1200EX with
the mains switch and the insertion module with
the POWER button (2) .
2) Adjust the desired volume with the volume con-
trol LEVEL (17) .
3) To switch off, press the POWER button again .
5.1 Operation of the CD / MP3 player
It is possible to replay audio CDs including those
you have burnt yourself (CD-R) and CDs with titles
in the MP3 format . In case of rewritable CDs (CD-
RW), however, problems may occur during replay
depending on the CD type, the CD burner and the
burning programme used .
Via the USB port, also MP3 files can be replayed
from a USB flash drive .
Note: Due to the large number of storage device manu-
facturers and device drivers, it cannot be guaranteed that
all storage media are compatible with the MP3 player .
5.1.1 Replaying music titles
1) Insert a CD with the lettering facing upwards into
the slot (5) until it is automatically retracted . If
there is already a CD in the unit, the display shows
the symbol .
IN
To change a CD, press the button EJECT (1) .
The CD is ejected . If the CD is not removed, the
unit retracts the CD after a few seconds .
2) Alternatively or additionally, a USB flash drive can
be inserted into the USB port (10) .
3) After loading, the first title starts . For standard
audio CDs, the display shows the title number
and the time already played (min . : sec .) .
For titles in the MP3 format, the file name passes
through the display, then the title number is
shown behind the letter "T" . When the button
DISP (12) is pressed repeatedly, information about
the title of the music piece, the album, the artist
etc . (ID3 tags) can be displayed . If no ID3 tags are
available, the display shows NO ID3 .
Note: When the button DISP is pressed during the
replay from a CD or USB flash drive, also information
about the station adjusted are displayed, see chap-
ter 5 .2 .3, paragraph "Information" . Press the button
DISP repeatedly until the desired information is dis-
played .
4) When the last title has been played, the unit re-
starts with the first title (continuous replay) .
5) To interrupt the replay, press the button
The display indicates S-PAUSE . When the button
II is pressed again, the replay will be continued .

IN
II (6) .
