Installation And Set-Up - brennenstuhl BCN 1221 Bedienungsanleitung

043909 BA_CO-Melder BCN 1221-0.qxp 01.10.15 09:49 Seite 25
BCN 1221
• with an air humidity below 30% or above 90%
relative humidity
• In direct sunlight, directly over a sink or cooking
device.
• Behind curtains, drapes, furniture or locations
where there is no air circulation.
• In unheated basement rooms and garages.
• In locations where the detector could be
exposed to chemical solvents or cleaners.
• Near ventilation openings, exhaust pipes and
chimneys.
• Near heaters or cooking equipment of any kind.
• In the vicinity of ceiling fans, heating vents, air
conditioners and fresh air vents.

4.3 Installation and Set-Up

INSTALLATION:
1. Remove the mounting plate by pushing it
upwards. Then, fasten it to the wall with the
screws provided at a height of 1 m – 1.5 m.
2. Connect the battery with the plus pole and
minus pole in the correct posi-
tion and close the battery cover.
Then hang the CO-detector in
place and secure it as shown.
3. Test the detector by pressing the
test button and holding it in for a
few seconds.
Operating Instructions
25