Installation - BOMANN SBS 2350 IX Bedienungsanleitung

Delivery scope Delivery scope
Delivery scope Delivery scope
Fridge: Fridge:
Fridge: Fridge:
5x glass shelf, 1x vegetable box, 4x door
storage rack, 1x egg tray
Freezer: Freezer:
Freezer: Freezer:
5x glass shelf, 1x freezing box, 4x door
storage rack, 1x ice-cube tray

Installation

Installation Installation Installation
Conditions for the installation location Condition s for the installation location
Condition Condition s for the installation location s for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 5 cm and to the side
-
walls each approx. 10 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Levelling the appliance Levelling the appliances doors
Levelling the appliance Levelling the appliance
If the doors are uneven and do not close parallel to
each other, the refrigerator door must be aligned.
Maximum tolerance compensation is 5 mm! Maximum tolerance compensation is 5 mm! Maximum tolerance compensation is 5 mm! Maximum tolerance compensation is 5 mm!
Open the door, loosen the locknut (1) with a
wrench (a)..
if the refrigerator door is too low
..
nut (2) counterclockwise counterclockwise to raise the door.
counterclockwise counterclockwise
if the refrigerator door is too high
..
nut (2) clockwise clockwise to lower the door.
clockwise clockwise
Once the doors are aligned, retighten the locknut (1).
Electrical Electrical connection Electrical Electrical connection connection connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
19
s doors
s doors s doors
, turn the adjusting
, turn the adjusting
electric electric electric