PocketWizard PLUS III Kurzanleitung Seite 6

Remote Flash Triggering
NOTE: With transmitting and receiving PocketWizard
zone, remote flashes will be synchronized with the camera.
Camera with Plus III
®
in hot shoe
(Transmitting)
Triggering a Remote Flash with your Plus
1. Attach a Plus III to your camera's hot shoe. You may also connect the
Plus III to your camera's PC sync port using the included cable.
2. Connect a Plus III to your remote flash via the appropriate sync cable.
3. Select a Channel and Zone A, B, C, or D via Channel Up/Down Buttons
and Zone Toggle Buttons. Set any other PocketWizard radios
to a matching Channel and Zone. (See the "Using Zones" section for
more information)
4. Take pictures normally at or below your camera's X-sync speed.
Momentarily pressing the TEST button will test trigger the flash.
wiki.PocketWizard.com
*See
radios set to the same channel and
®
Any PocketWizard receiver
connected to remote flash
(Receiving)
for more mounting suggestions.
*Optimal Mounting Position
III Transceiver
®