Ayce PLD2372 Gebrauchsanweisung Seite 42

3. Operation of the appliance
a. General operation
WARNING:
• Before operation, make sure that you have read and understood all of the safety instructions,
also make sure that the tool is switched o .
• Ensure that the supply voltage is the same as shown on the rating label. Connect the plug
to the power supply.
• Always determine the correct operating temperature for the respective activity.
• First check the properties of the material to be processed at the lowest temperature setting
and then gradually increase the amount of air ow in an inconspicuous area.
• The temperature will drop if the distance between the air outlet / nozzle and the material
being processed decreases.
• The temperature is dependent on the material you are working on.
WARNING:
If you are not sure about the correct setting, start with a low temperature setting
and gradually increase the temperature until you achieve optimum results
b. Mounting the correct accessory
Description
Icon
Glass protector nozzle
Re ector nozzle
Reducer nozzle
Flat nozzle
Scraper
Purpose
Protection windows when
stripping frames
Soldering pipes
Welding, shrink sleeving (heat
concentrated over small area )
Drying, thawing (heat spread over
wider area )
Stripping paint and varnish
c. Stripping paint
• Mount an appropriate accessory.
• Set a high air temperature
• Switch the tool on
• Direct the hot air onto the paint to be removed.
• When the paint softens, scrape the paint away using a hand scraper
WARNING:
• Do not strip metal window frames, as the heat may be conducted onto the glass and
crack it. When stripping other window frames, use the glass protection nozzle.
• Do not keep the tool directed at one spot too long to prevent igniting the surface.
• Avoid collecting paint on the scraper accessory, as it may ignite. If necessary, carefully
remove paint debris from the scraper accessory using a knife.
d. Stationary use
This tool can also be used in stationary mode.
• Place the tool onto the workbench.
• Secure the cable to prevent pulling the tool o the workbench.
• Carefully switch the tool on.
WARNING:
• Make sure that the nozzle always points away from you and any bystanders.
• Make sure not to drop anything into the nozzle.
MAINTENANCE
CAUTION!
Always disconnect the device before performing any adjustment or maintenance operation.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
| 82 GB
81