Rebel ZAB0030 Bedienungsanleitung Seite 27

1. Press and hold the power button to turn the kick scooter on. Check the battery level
before operation.
2. Step on the deck with one foot and use the other foot to push away to make the
wheels spin. When the wheels are already in motion, press the accelerator slightly
to start the vehicle.
NOTE: the device has a NO ZERO SPEED START function - the accelerator will not be
effective unless the speed of the scooter is at least 5 km/h.
3. Press the brake's handle to slow down or stop the scooter. Do not stop too suddenly
as it may pose risk of falling!
4. Press and hold the power button again to turn the device off when it's no longer in use.
Note: If you don't switch device off, it will stay on for 10 minutes allowing you to step on
it and continue riding without engaging on/off switch. If not used within that period, it will
automatically switch off after the time is up.
The scooter has a build in speed meter. It automatically turns on when the scooter is
switched on and shows current speed of the scooter.
Range (cruise distance on one battery charge)
Speed as well as distance on one battery charge the vehicle can cover depend on many
factors, and thus may decrease in relation to:
• topography: uneven surface will shorten the range and decrease speed;
• weight of the user: the speed and range will be lower in case of heavier load;
• temperature: extreme temperatures shorten the range and lower the speed, the
battery performance decreases quickly in cold conditions;
• maintenance: proper handling, charging, etc. will optimize the range distance and speed;
• speed: moderate, economic driving will optimize distance; while frequent starts,
stops, changes of speed reduce the distance.
Disc brakes adjustment
If you feel the disc brake is too
tight or loose, use the screw cap
indicated to adjust it:
• rotate clockwise to tighten the
brake,
• rotate it counterclockwise to
loosen the brake.
User's manual
Operation steps:
Speedmeter
EN
27