Einhell Global HKL-G 1400 Bedienungsanleitung Seite 12

Anleitung HKL_G 1400 14.07.2003
GB
Important!
Wear ear muffs and goggles.
1
2
A B
Parallel cuts
1. Release the lock screw 1.
2. For 90° cuts, adjust the parallel stop 2 using the scale on groove
A, for 45° cuts adjust the parallel stop 2 using the scale on groove
B. Observe the saw blade width.
3. Tighten the lock screw.
Important!
First make a trial cut.
1
Adjustment of the shoe (cutting angle)
1. Release the 2 lock screws 1
2. Adjust the shoe to the desired angle between 0 and 45°.
3. Tighten the lock screws 1.
10
9:40 Uhr Seite 10
Adjustment of the cutting depth
1. Release the lock screw.
2. Swing the shoe downwards.
3. Adjust the cutting depth using the scale.
The saw teeth must project approx. 2 mm out of the wood.
4. Tighten the lock screw.
1
Important!
Pull out the plug before
making any changes to the
circular saw!
2
1
4
Changing the saw blade
1. Open the hinged guard hood 1 and hold.
2. Use the face spanner 2 to stop the saw blade from moving.
3. Undo the screw with the wrench.
4. Remove the flange 4 and the saw blade by dropping down
and out.
5. Clean the flange and insert a new blade. Note the direction
of rotation (see arrow on the guard hood).
6. Tighten the screw and check for concentricity.
1