Operating The Co2 Trigger; Dismantling Your Lance; Product Care Advice - Lance Lab AR 8 Bedienungsanleitung

Operating the CO2
Adjustable Telescopic Lance
To unlock.
To lock.
1. Only press in 1 second burst. This enough for a single treatment (pressing for 2 – 3
seconds will empty the entire powder chamber).
Please note: A full powder chamber is sufficient for 3 wasp nests (yellow jackets
nests). A 12g non-threaded / threaded CO2 cartridge = Approximately 10 – 1
Dismantling your lance: AR 8
Adjustable Telescopic Lance
1. Remove the CO2 trigger from the lance by unfastening the trigger strap. Keep your
CO2 cartridge inside the lower casing with the trigger in the lock position. This will
avoid loss of CO2 and allow continued use of the cartridge until it is empty.
2. To dismantle your lance, please follow the assembly instructions in reverse order.
Product Care Advice : AR 8
Adjustable Telescopic Lance
Storage places to avoid:
1. Areas subjected to rain, high humidity or dirty environments.
2. In direct sunlight, or places of extreme heat such as a closed car on a hot
summers day or extremely cold environments.
3. Places which experience strong vibrations.
4. Moisture will cause clogging of dust that can cause a blockage. Store your lance in
dry conditions, with an empty powder chamber.
Caring for your AR 8:
1. Use a soft brush or soft, dry cloth to remove dust from the lance, hose and carry
case.
2. Do not scratch hard objects against the lance.
3. The product should be cleaned with a soft, dry cloth only. Do not use volatile
substances or cleaning products as these can cause damage.
: AR 8
Trigger
second bursts/uses.
ALWAYS LOCK THE TRIGGER AFTER USE.
EN
-11-