Mhouse RT3N Handbuch Seite 12

Memorizing a new transmitter like a previously memorized transmitter
It is possible to memorize a new transmitter so that it operates exactly like a
previously memorized one. If the old transmitter was memorized in Mode I, the
new one will also operate in Mode I and a single memorization stage will be
required. If the key on the old transmitter was memorized in Mode II, also the
key on the new transmitter will be memorized in Mode II and will perform the
same function. If you wish to memorize more than one key you will have to
perform a memorization procedure for each key.
Memorizing a new transmitter exactly
Table [F]
like a previously memorized
transmitter
1 Press the key on the new transmitter
(new TX) to be memorized and hold it
down for at least 3 seconds, then release
it
2 Press the key on the previously
memorized transmitter (old TX) and hold
it down for at least 3 seconds, then
release it
3 Press the key on the new transmitter
(new TX) again and hold it down for at
least 3 seconds, then release it
4 Press the key on the previously
memorized transmitter (old TX) and hold
it down for at least 3 seconds, then
release it
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
10 – English
Example
New TX
3s
Old TX
3s
New TX
3s
Old TX
3s