Bestway 58495 Gebrauchsanleitung Seite 5

Assembly (You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure
nothing is damaged. If equipment is damaged,immediately notify the retailer
from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete
slab. Position the sand filter so the Ports and Control Valve are accessible
for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on ground or a certain
pedestal made of wood or concrete before use to prevent the sand filter from accideutally falling.
Fully assembled sand filter will exceed 18kg. The mounting holes should be 8mm in diameter and
spaced 86mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to fasten the sand
filter to the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 9kg bag should suffice. If you do not use the recommended size filter
sand, filtering performance will be reduced and the sand filter may damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to
submerse the Skimmer on the Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
S-S-006163/21.0x28.5cm/58495/ 1000gal 欧规砂滤器说明书/JS-YF-2017-B-03640-英
C
5
86mm
Ф8mm
4
MAX.
MIN .
MAX
MIN
C
C