Maintenance And Inspection - Alfra Tmh 50 R Bedienungsanleitung

Maintenance and inspection of the hand-operated lifting magnet
The user is obliged to maintain and service the hand-operated lifting magnet TMH 50
specifications in the operating manual and according to the country-specific standards and regulations
(e.g. ASME B30.20B, DGUV-Information 209-013; AMVO).
Before every use...
visually inspect the hand-operated lifting magnet for damage
•
• clean the surface of the work piece and the underside of the magnet
• free the underside of the magnet of rust, chips or unevenness
Weekly...
• inspect the lifting magnet and activation lever for deformation, cracks or other defects
• make sure the activation lever is working properly and latches correctly into place
• inspect the bottom of the magnet for scratches, pressure points or cracks. Have the magnet repaired by the
manufacturer if necessary
Monthly...
• check the markings and labelling on the lifting magnet for legibility and damage and replace them if
necessary
Annually...
• have the load-bearing capacity of the lifting magnet checked by the supplier or an authorised workshop
Unauthorised repairs or modification to the lifting magnet are not permitted.
If you have any questions, contact the manufacturer.
in compliance with the
R
17