External Temperature Sensor - Ontech Relay 9015 Schnellstartanleitung

If you control your unit with an Android Smartphone all information
from the SMS will automatically be read in and presented in the main
window in the app.

External temperature sensor

An external temperature sensor can be connected to the input con-
nector marked "Temp" on the bottom of the unit. You can choose if the
internal or external sensor shall control thermostat and temperature
alarms. The value from both sensor are shown in the status-SMS and in
the Android app.
Activate temperature alarm and select active sensor
On order to set the temperature alarm and select ective sensor, you
must have a smartphone.
• With an Android Smartphone, download the app Ontech Control
at Google Play.
• With another type of Smartphone, for example Iphone and
Windowsphone. Open the browser in the phone and go to www.
ontechgsm.com/set.html. Follow the instructions on the screen.
Installation of wired alarm sensors
Ontech Relay 9015 has two alarm inputs (A and B) for wired alarms sen-
sors such as PIR, magnetic switch, fire alarm etc. The inputs can be set to
Normally Open (NO) or Normally Closed (NC).
Connect the attached cable in the Alarm contact and connect your
alarm sensor according to fig 1 (NO) or fig 2 (NC). N.B. You can have dif-
ferent settings (N.O. or N.C.) int the two inputs on the same unit.
Declaration of conformity
Onvako AB, Datavägen 14A, 436 32 Askim, Sweden, hereby declares that
the product Ontech Relay 9015 is in conformity with the provisions of
the Radio & Teleterminal directive R&TTE 1999/5/EG and the Low Volt-
age directive 2006/95/EC.
- 13 -