Handy 10050 S Gebrauchsanweisung Seite 5

e
rror syMbols
• Er.b.L - Low energy level: Replace battery.
• Er.t.L - Too low operating temperature: Wait until the appliance warms up.
• Er.t.H - Excessive operating temperature: Wait until the appliance cools down.
• Er.d.H - Out of Range: Go closer to the measurement point.
• Er.d.E - Measurement error: Try again.
• Er.5.L - Low level: Use a reflection board or try another surface.
• Er.5.H - Reflective laser signal too strong: Use a reflective board or try another
surface.
• Er.H.F - Hardware error, if the fault is still there after being switched off and on
or after power down, contact your service representative for repairs.
c
onnectinG to a sMartphone
To connect to a mobile device, download a software
compatible with your device's software:
• Give the required access to the program so that the program works properly.
For example, the software asks for access to the camera because there is a
possibility to record on a photograph.
• Prepare the device, insert the battery and turn it on, then press and hold the 4
button on the device with the bluetooth icon.
• After granting permissions, start the program and click on "bluetooth",
touching the magnifying glass in the top right corner starts search.
• In the hit list, click the name to edit the name of the device.
• On the result list, select the icon for the device you want to connect, then use
the device to automatically forward the data to the mobile app.
• By clicking on the left icon you can record data on a photo. Take a picture
of the part you want to measure, then use the top icon set to select the
appropriate plane and draw the dimensions. Then select the numbered lines
in the top left corner to start measuring the appropriate side. Once you've
finished the measurement, you can save it as an image to your cell phone
gallery, but you can share the image with other people either via email, social
network or other communication channels.
• Using the right icon, you can view the last 8 measurements in graphs and
spreadsheets. You can save the measurement values for each location either
in separate log files that you can tap on the document icon at the bottom of
the screen.