Handy 10050 S Gebrauchsanweisung Seite 4

Insert / replace battery
Unscrew the screw that secures the battery cover and open the cover. Insert the
two 1.5 V AAA batteries in the battery compartment according to the polarity.
For environmental reasons, we recommend using a rechargeable battery. Up to
3000 measurements can be made with a single charge.
Getting Started, Device Setup
• Turn on the device by pressing button 2.
• Press button 7 for a long time to change between units.
• You can cancel the last measurement of the device by pressing button 5
(Clear). Press and hold the same button to turn off the device. If the device is
not used for 3 minutes, it automatically switches off to preserve the battery
charge.
• Press button 4 briefly to change the starting point of measurement. (Front
or back side of the device). By default, the machine sets the back side as the
starting point for each startup.
M
easUreMent
To measure, press button "2" briefly. Press and hold the 2nd key to switch to
continuous measurement mode. At this time, the device uses a built-in laser
to continuously measure the distance of the given point, which is signaled by
beeping.
Area Calculation
To start this function, press button "3" once and then first measure the flashing
long side shown by the icon and then the shorter.
Volume Calculation
To start the function, press the "3" button two times until the cube icon appears
and then measure the flashing sides in the figure to determine the desired
volume.
Indirect measurement (if it is not possible to directly measure the given
section)
Using the Pythagorean theorem calculates the length of the desired section
from two other available data. Press the key "3" three times until the triangle
appears in the display, then measure the diagonal of the triangle, then measure
the other side that closes the previous side with an acute angle. After measuring
the two values, the third side length appears on the display. If you want to the
wanted measurement can be calculated out of two triangles.
Check previous data
The device is capable of storing 20 data. After switching on the device, press
the button 6 (M/S) and then press the 7 (+) button again to switch between 20
program positions.