How To Operate - Outwell SQUALL Tent Pump 12V Bedienungsanleitung

READ THE FOLLOWING INSTRUCTIONS AND WARNINGS
BEFORE USING
IMPORTANT
1. Power supply must be 12 Volt DC.
2. This superior quality pump is specially designed to
auto inflate tents with high pressure valves, and not for filling tires and
continuous use.
3. This pump is not designed for continuous use more than 15 minutes and
extended operation can cause motor overheating or damage the pump.
(Recommend : Rest 30 minutes for every 15 minutes used).
Caution- To reduce the risk of electric shock, do not operate under wet conditions or expose to water. Always
store in a cool dry area, away from heat and moisture.
Caution- To prevent fuse from being blown, please do not use cigarette lighter socket to provide power other
than for the pump own use, please make sure your protection fuse is 15 amp, or above.
WARNINGS
1. Never attempt to disassemble or repair.
2. Do not leave this pump for children and without adult supervision.
3. Never allow sand,small rocks or other articles to be sucked into the
inflating or deflation port while operating.
4. Use this unit only for its intended use as described in these instructions.
Do not use attachments not recommended by the manufacturer.
5. Never leave the pump unattended while in use. Keep the cord away from
heated surfaces.
6. To disconnect power, press "
then remove DC charger or power plug from the outlet.
7. Avoid touching the hose by the 'INFLATE ' port whenever in use..

HOW TO OPERATE

1. Connect pump cigarette lighter plug into a DC 12V power source.
2. To inflate: Connect hose to "INFLATE" port of the pump with
opposite end into the inflatable valve. Secure firmly with nozzle adapter.
3. Press "PSI/BAR" button to select unit measure
4. Press " " or " " button to set the desired pressure value.
5. Press " " button to start inflation. Pump will stop
automatically once reaches the set pressure value.
6. (You may now detach the hose from valve and tightly close the valve cap).
To continue adding more air pressure or inflatable firmness, please
reset new desired pressure value and restart from step 4.
UK Instruction Manual
" button until air pump fully stops operating,
2
Hose by the 'INFLATE 'port
Start/Stop
Pressure Down
Pressure Up
High Pressure Valve