Werbung
Verfügbare Sprachen
Verfügbare Sprachen
L SATA Card 2way with Raid, PCI
When using more than one hard disk with SATA
RAID controller, always ensure they are the same
type or design. Problems can occur when using dif-
ferent types of hard disk due to incompatibility.
SATA PCI 2-Way Raid Controller Instruction
Guide
Installing Hardware:
You must open your computer to install the card.
Ensure that you have unplugged your computer
from the power supply. If you are not familiar with
the internal layout of your computer, please consult
the manual of your computer or ask an expert.
1. Switch off all connected devices and your
computer.
2. Unplug your PC from the power supply before
beginning installation.
3. Open the cover of your computer.
Note: Static electricity can damage both the
card and your computer. Discharge yourself by
touching a metal object.
4. Select a free PCI slot. Remove the cover plate for
this slot. Keep the screw - you will need it to
secure the card.
5. Hold the card at the edge of the board and insert
it into the free PCI slot. Carefully press the card
into the slot until the holding bracket is lined up
with the casing and the gold-plated contacts have
disappeared within the slot.
6. Secure the card using the slot plate screw you
removed earlier.
7. Close the case of your computer and plug it in to
the power supply again.
8. Switch your computer on again and continue with
the driver installation.
Card
PCI
Installation on Windows XP:
After inserting the card, the new Found new hard-
ware wizard will appear. Select the option "Install
software from a list or specify location (for advan-
ced users)".
Next
Should a window appear with the question "What
do you want Windows to do?", choose the option
"Take no action" and click
this location in the search:" and enter "D:\"(whereby
D: represents the initial of your disc drive and must
be changed if necessary).
"The wizard could not find the software on your
computer for..." appears, click
make sure you have entered the information correctly .
If the message "The software you are installing for
this hardware: has not passed the Windows logo
test which checks compatibility with Windows XP."
appears, click "Continue installation". The necessary
files are now copied from the CD
Important instructions for Windows XP:
You can check whether controller has been instal-
led successfully by selecting Start
System
Hardware
some systems, you must click Switch to Classic
View to see the System icon). The following should
appear without yellow exclamation marks:
SCSI and RAID controller
• Silicon Image Sil3112 SATARaid controller
Slot plate
insert enclosed driver CD.
Ok
Select "Include
Next
If the window
Back
and
Finish
Control Panel
Device Manager (in
Werbung
