iCES IBT-3 Bedienungsanleitung Seite 17

Power setup
Connect the AC/DC adapter to the DC in socket on the speaker back panel and
plug the adaptor into the mains socket.
Using the remote control
The battery
To get your remote control working intially, pull the clear tab from
the battery compartment located at the bottom of the remote.
If your remote becomes intermittent or you find you have to
move closer the unit to operate, then probably batteries need to
be replaced.
To replace batteries, slide the holder out from the base of the
remote. Remove the battery and replace with a 3 volt Lithium
CR2025.
Aux-In line in type
Requires a 3.5mm cable (included)
1. When the Tower is powered on, press "STANDBY", then entering into the
AUX mode automatically.
2. Connect a 3.5mm cable to the Aux-in jack at the rear. Connect the other end
of the 3.5mm cable to an MP3 player or other audio source.
3. Use the controls on the top panel to begin playing audio routed through the
unit or press "AUX" button on the remote.
Using Bluetooth
1. Power on the unit and press "MODE" button to change to bluetooth mode or
press "BT" button on the remote, the LED display will display "BT".
2. The previous paired device will connect to speaker tower automatically when
each time changing to bluetooth mode.
3. Press play/pause button and hold for 10 seconds, after a beep tone, the tower
speaker is prepaired to be paired again.
4. Search "ICES IBT-3" and pair it, input the password "0000" if necessary.
5. If it still doesn't work, please reset the Bluetooth and follow above step again.