Seite 1
Aufbauanleitung / assembly instructions mod. 2086 Sauger suction cup 10 x 30 25 x 60 10 x 30 M10 x 65 4,5 x 50 1. Montagematerial 2. Den Unterbau auspacken und aufstellen. 1. fitting material Die Holzdübel in die Halteplatte des Unterbaus einstecken.
Seite 2
7. Check, if the rotary plate is on the same level as the main plate. (Please note that a difference in height up to 1,5 mm can not be avoided because the basic materials are natural.) If not... 2 / 5 2086 Änderungsdatum: 29.06.18...
1 mm per whole turn. By turning the mounting screws and the adjusting screws partially, the rotary plate can be adjusted to the hight and to the angle of slope. 3 / 5 2086 Änderungsdatum: 29.06.18...
Seite 4
Absenkung eindrehen). Drehteller anheben / to lift the rotary plate: 10a. Die Befestigungsschrauben heraus- 10b. Die Justierschrauben nun eindrehen drehen (z.B. 1/4 Umdrehung = ca. (ca. 0,5 Umdrehung = 0,5 mm 0,5 mm Anhebung). Anhebung). 4 / 5 2086 Änderungsdatum: 29.06.18...
Seite 5
11. Put the bolt of the rotary plate into the bush. Check again the hight / alignment and if needed, adjust again (P. 6 – 10). 12. Fertig (Grundzustand). 13. Fertig (ausgezogen). 12. Ready (initial state). 13. Ready (pulled out). 5 / 5 2086 Änderungsdatum: 29.06.18...