HitachiSoft StarBoard T-19WX Benutzerhandbuch Seite 24

T-19WX
StarBoard
(1) Connect the RGB cable to the VGA input port on the side of the StarBoard, and
tighten the screws to fasten. Connect the other end of the cable to the PC VGA
port, and tighten the screws to fasten.
(2) Connect the USB cable to the USB port on the side of the StarBoard. Connect the
other end of the cable to a USB port on the PC.
(3) Connect the audio cable to the audio input port on the side of the StarBoard.
Connect the other end of the cable to the audio output port on the PC. (Do this
only if you plan to use the StarBoard's built-in speakers.)
(4) Connect the AC adapter connector to the StarBoard power connector.
(5) Connect the power cable to the AC adapter, then plug the power plug into power
socket.
(6) If outputting the StarBoard screen to external equipment, connect the RGB cable
to the VGA output port. Connect the other end of the cable to an input port on the
external video equipment.
How to install StarBoard Software
For details on how to install StarBoard software, see "StarBoard Software Installation"
in StarBoard Software x.x User's Guide
1-10
Introduction
English