Charging The Power Pack; Charging Using The Plug Charger; Charging Using The 12 V Motor Vehicle Charging Cable; Starting Aid - Eufab 16643 Bedienungsanleitung

6.2 CHARGING THE POWER PACK

Charge the Power Pack fully after purchase or before using for
the first time. Leave the Power Pack connected to the charger
for a maximum of 48 hours.
To check the charge status, first remove the charging cable,
then press the control button for the charge status (position
8 in the overview). If the voltmeter for the charge status
(Position 6 in the overview) shows a value of 50% or less,
yellow section (Figure 5), then the Power Pack must be
charged. If the value is over 50%, green section (Figure 6), the
Power Pack is ready for use.

6.2.1 CHARGING USING THE PLUG CHARGER

Switch off the compressor and the working light. Remove all consumers connected to the Power Pack. Plug the coaxial connector
of the plug charger (Position 13 in the overview) into the charging socket of the Power Pack (Position 1 in the overview). Now,
connect the plug charger with the mains socket. The charge control lamp (Position 2 in the overview) now lights up. If the
battery is completely empty, the charging process will take max. 48 hours. After charging, first disconnect the plug charger from
the mains socket, then disconnect the coaxial connector from the charging socket of the Power Pack. If you now press the push
button for the charge status (Position 8 in the overview), the Voltmeter shows a voltage of approximately 13 V for the charge
status (Position 6 in the overview).
Do not leave the plug charger connected for longer than 48 hours!

6.2.2 CHARGING USING THE 12 V MOTOR VEHICLE CHARGING CABLE

Switch off the compressor and the working light. Remove all consumers connected to the Power Pack. Plug the coaxial connector
of the 12 V motor vehicle charging cable (Position 14 in the overview) into the charging socket of the Power Pack (Position 2 in
the overview). Now connect the 12 V plug to the 12 V socket of your vehicle. The charge control lamp (Position 1 in the overview)
now lights up. If the battery is completely empty, the charging process will take approximately 17 hours. After charging, first
disconnect the 12 V plug from the 12 V socket of your vehicle and then disconnect the coaxial connector from the charging socket
of the Power Pack. If you now press the push button for the charge status (Position 8 in the overview), the Voltmeter shows a
voltage of approximately 13 V for the charge status (Position 6 in the overview).
CAUTION: Only charge the Power Pack when driving or when the motor is running, otherwise there
is a risk that the starter battery of your vehicle may be discharged.

6.3 STARTING AID

Remove all devices connected to the Power Pack. Make sure that the Power Pack is fully charged. To do this, press the push
button for the charge status (Position 8 in the overview). If a charge status between 50% and 100% is shown, the Power Pack
is ready for use.

6.3.1 CONNECTING THE POWER PACK (VEHICLES WITH NEGATIVE EARTH)

Switch off the ignition and all electrical consumers of the vehicle (radio, lights, rear window heating, seat heating etc.). Apply
the parking brake. First connect the red (+) pole callipers (Position 5 in the overview) to the plus terminal of your vehicle battery.
The black (-) pole callipers (Position 4 in the overview) is connected, as far as possible from the battery, to the motor block or
chassis (not to a painted part).
Image 5: Battery must be
charged
Figure 6: Battery is fully
charged
11