Scubapro Module Light Benutzerhandbuch Seite 2

SCUBAPRO MOdUle light - USeR MAnUAl
Welcome to SCUBAPRO and thank you for purchasing the Module Light. This
manual provides you easy access to SCUBAPRO Module Light's key features
and functions. Should you wish to know more about SCUBAPRO UWATEC
diving equipment, please visit our website www.scubapro-uwatec.com.
Module Light Overview
housing
The casing of the SCUBAPRO Module Light battery pack is made of Delrin, a
lightweight, low-friction and wear-resistant plastic, capable of operating at high
temperatures. The casing of the SCUBAPRO Module Light head is made of
salt water resistant aluminum. These light heads have been treated with three
processes to produce a hard, corrosion-resistant surface.
Water tightness
The Module Light battery packs and light heads obtain their water tightness
by means of durable NBR O-rings. These O-rings are extremely important and
require your special care and attention. The O-rings must be free of impurities
and grooves; they should shine slightly due to silicone grease. If not, the O-rings
should be cleaned with a soft cloth that does not shed fluff and then lightly
greased with silicone grease. Every time the SCUBAPRO Module Light battery
pack is charged, the condition of the O-rings should be checked. It is advisable
to replace these O-rings when in doubt about their condition and in any case after
approximately 50 dives. They must be replaced with great care. The condition of
the seal's surface should also be checked for damage.
Rinsing
After each dive, it is highly recommended to rinse your SCUBAPRO Module Light
battery pack and light head with fresh water. While rinsing make sure that the
battery pack is attached with light head and umbilical to prevent water entering
the system.
Charging your Module Light
After purchase and before any use, the batteries of the battery pack need to be
charged completely.
To charge the batteries of your SCUBAPRO Module Light, the light head has
to be disconnected from the battery pack. If an umbilical is fitted between the
battery pack and the light head, it is advisable not to disconnect the umbilical
from the battery pack but to disconnect the light head from the umbilical. While
connecting and disconnecting parts, please pay attention not to damage the
seal's surface. After disconnecting the light head, the charging plug can be fitted
to the battery pack or cable. The black socket on the charging plug fits the black
coupling socket on the charger. Push the sockets together until they hook up.
As soon as the charger is connected to the main system, the charging will begins.
When disconnecting the charger from the dive light or battery pack, unplug the
charger from the wall outlet before disconnecting the small black sockets. When
unplugging the sockets, please be careful not to pull the wires. Charged batteries
get very warm as the energy is converted into heat, so warm batteries usually
indicate they are fully charged.
1