Remote Control - Niko-Servodan 41-350 Gebrauchsanweisung

GB
The light switches off automatically after a preset period, when
the presence detector does not register activity within the
detection area.
Manual switching off of lighting
If a pushbutton is used, a short press will switch off the light.
After a blackout period of approx. 10 secs the PIR is ready again
for auto switch on.
Dimming of lighting
A long press of the pushbutton enables the lighting to be
adjusted up/down.
Manual override using IR Remote.

Remote control

Setting/Functions via the IR Remote (accessory):
The IR Remote provides options for manual on/off and dim, for
selecting another application, carrying out a test and also other
parameters.
On and Off:
The lighting in zones 1 and 2 is manually switched on and off at
the same time regardless of light level.
Dim up and Dim down:
The lighting in zones 1 and 2 is manually adjusted at the same
time.
Automatic:
Control functions according to the application selected.
Test:
Walk test, testing detection area by activating built-in presence
detector; the light sensor does not work.
Automatically reverts to operating mode after 5 minutes.
Parameters:
Select between Man and Auto applications.
Reset parameters to factory settings.
Setting desired light level in zone 1 via Set 1.
Setting desired light level in zone 2 via Fact. 2.
Setting of off delay for zone 1 via Time 1 (1–60 mins in steps of 1
min. and 10 mins)
Setting of fade time in the light fi ttings via Fade (0–15 steps in steps
of 1.)
For further information about the IR Remote see the installation
and user manual for IR Remote model 41-922.
If the 360° DALI/DSI presence detector is in "edit mode" (unlock),
then the IR buttons On and Off do not work.
Operation & maintenance
Contact a qualifi ed electrician in the event of a fault or
breakdown.
8(17)
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com