Planet POE-151 Bedienungsanleitung Seite 9

5.3 PoE Injector and PoE Splitter Installation
For non PoE remote device or Ethernet equipment, the PoE Injector and
PoE Splitter can runs in pair to provide DC Power for those devices, the
table below shows the model of PLANET PoE Splitters:
Model PoE Standard
POE-151S IEEE 802.3af
POE-152S IEEE 802.3af
POE-162S IEEE 802.3at
1. Follow step 1, step 2 and step 3 of Section 5.2 for the connection.
2. Connect the UTP cable in the package from "Ethernet" of the PoE
splitter to the RJ-45 port of remote device.
3. Connect proper DC plug from "DC OUT" of PoE Splitter to the remote
device.
Ethernet Switch
Data
DC
Power
AC
Figure 4: Connection Architecture via PoE Injector and PoE Splitter
Please ensure the PoE Splitter output voltage is correct
before applying power to remote device otherwise, it may
damage the remote device.
Note
DC Power Out
5V / 12V DC
5V / 12V DC
12V / 24V DC
100 meters
PoE-IEEE 802.3af
Ready
Power in-use
Data Power
PoE
POE-151/152
PoE Injector
Pass-thru. Speed
10/100Mbps
10/100/1000Mbps
10/100/1000Mbps
PoE
Ethernet+DC Ethernet 5V 12V DC OUT
POE-151S
PoE Splitter
100Base-TX UTP
DC Power Line (DC)
AC Power Line (AC)
PoE 100Base-TX UTP with PoE
Data
DC
Wireless AP
Power
1-5