Hama TH-100 Bedienungsanleitung Seite 5

• Press the MODE button (3) to
save the settings and return to the
normal display.
Note
• The weekday is set
automatically when setting the
date manually.
• In the 12-hour format, PM
(from noon to one minute
before midnight) appears
before the time.
• The settings that were made
up to that point are not saved!
5.4 Temperature measurements,
maximum/minimum display
• In clock mode, press the SET
button (3) to choose between °C
(Celsius) and °F (Fahrenheit).
• Press the ADJUST button (4) to
display the maximum or minimum
values for temperature and
humidity recording.
• Press the ADJUST button (4) for
about 2 seconds to delete these
recordings and start recording
again.
Note
If the ambient humidity is less
than 20%, LL is shown in the
corresponding field on the display.
4
5.5 Alarm and hourly chime
• In alarm mode, press the ADJUST
button to switch the alarms on
or off. The bell symbol stands
for the alarm and the propeller
symbol stands for the clock hour.
If one of these symbols appears
on the display, the relevant
functions are activated.
• If the alarm is switched on, it
will stop going off automatically
after about a minute or when the
SNOOZE button (6) is pressed.
If you press the SNOOZE button
(6), the alarm will go off again
four times.
5.6 Moon phase display (2)
A B
E F
A: New moon
B: Waxing crescent
C: Half moon (first quarter)
D: Waxing half moon
E: Full moon
F: Waning full moon
G: Half moon (last quarter)
H: Waning crescent
C D
G H