How To Disassemble And Clean - Fridja f1900 Bedienungsanleitung

HOW TO D IS AS SE M BLE AN D CL EA N
1. Switch OFF and unplug the power cord from the wall outlet. ausstecken.
• Extract all the remaining pulp in the juicing bowl before
Note |
stopping the juicer.
• For easier clean up, operate the juicer for an additional 30
seconds after the juice is extracted.
• When the drum lid is stuck, press the REVERSE - OFF -
FORWARD button in this order, switching back and forth 2 to
3 times to dislodge. Then place hands on top of the drum
lid and firmly press down simultaneously turning the drum
lid counter clockwise to open.
2. Turn the drum lid counter clockwise to open.
3. Lift the bowl on the base so that its grey arrow lines up with the black
arrow on the base.
22
ENGLISH
Note | • When moving the
appliance, do not
lift by grabbing the
feeding tube. Always
lift the appliance by
grabbing the base or
handle.
f1900 FRIDJA WHOLE FRUIT SLOW JUICER
4. Remove the juicing screw/auger, strainer, and rotation wiper unit from
the juicing bowl. Clean with provided brush.
Note |
• Immediately clean the juicer after each use. If remaining
residue in the juicer dries up, it can make disassembling
and clean-up difficult. The excess build up can cause poor
performance in future uses.
• For easier disassembly, place the top-set in the sink and run
the water through from the top of the top-set.
• Thoroughly dry the bottom of the juicing screw where it
connects to the metal cylinder shaft on the base.
5. Place the juicing bowl under running water and unplug the compression
silicone to clean the pulp spout.
TIP |
• Soak the juicing bowl in a solution of warm water with
baking soda or a little bit of bleach to clean the excess
build-up.
23